1. Pre-prepared:
a）Clean up debris around the mill impeding the operation, checking safety facilities are completed properly.
b）Check whether there has been a dangerous location in the machine!
c）Check the ground surface to the grate plate center distance (that checks fill rate) whether it is in line with requirements;
d）Check anchor bolts, liner bolts, cylinder bolts connected with the hollow shaft, large gear connected whether there is loosening bolts, if loose should be tightened;
e）Solid manhole cover will be secured tightly.
f）The lubricants must be filled .
2. Boot sequence:
a）Starting out conveying equipment;
b）Activate the mill. (If no prior material exists within the mill, then starting the same time as starting feed mill equipment)
3 Parking order
a）To stop the feed mill equipment;
b）Stop grinding;
c）Stop discharging conveying equipment.
4. Handling Precautions
a）After the mill stops, turn the mill semi-circle every 5-10 minutes, until the mill is cool, in order to prevent generating too high a temperature stress on shaft of endcovers.
b）Always check the adequacy of the bearing lubricant;
c）If there is a long time of stop, balls should be poured out to prevent the deforming of the cylinder.